- Pants and trousers for girls there are various types of pockets: a frame, valve, patch, pockets in the seams on the front halves of trousers, etc. 
the Pockets have a different direction: horizontal - parallel to the upper cut of the pants and tilted during the hand. Pockets located at a distance from the upper edge, equal to 5 - 7 cm Length of the cut of the pocket 14 - 14.5 cm (depending on size). For the manufacture of pocket, you need the following items: piping of the fabric top 2, valance - 1, burlap, cotton-fabric - 1.
On forward halves of trousers on the auxiliary pattern outline pockets three lines: one along and two across the ends of the pocket. Bsli piping scheduled to be participate folded in half, for easier handling plan two auxiliary lines at a distance equal to twice the width of the frame (Fig. 90, a). Under the location of the pocket from the inside pull the burlap so that the top slice it coincided with a top layer of pants.
In the process of learning the burlap primetyvajut two lines (one is at a distance of 2 cm from the upper edge of the pants, and the second at a distance of 3 cm from the bottom of the pocket) or fix them with pins. Piping bend with wrong side inside; upper facing iron through protohellenic, bent along the middle, lower bend so that the bend took place at the distance of 1.5 cm from the edge. Press make piping bends towards the auxiliary lines primetyvajut, and then pritachivajut seam width 0.5 cm, securing at the beginning and at the end of the line.
Pocket cut from burlap, by bending in different directions, the seams obrazek. Obtachku is introduced into the incision pocket and straightened, forming a framework that spawn and priorivet (Fig. 90, b). Frame and the corners tighten from the inside and fasten the ends of the pockets double machine stitching.
In the products of thin tissue slice bottom piping bends at 0.5 - 0.7 cm and scribbled on the burlap at a distance of 0.1 cm from the fold. The products of the thicker tissue of the inner section of piping overcast on emergency vehicles and scribbled on the burlap without bending. Bend along the burlap, folded it in half, and set the location of the valance so that it is positioned above the grub pockets 1 see the Valance put on sackcloth, bends on three sides and scribbled at a distance of 0.1 cm from the bent sections.In the products of malosemeyka tissues are allowed to Topstitch the valance on a machine with a zigzag stitch with a width of 0.3 cm.
Burlap valance with laid out so that the upper section of it was parallel to the top cut the front halves of trousers. Then the front half of the pants are folded and secured the burlap with the valance that is parallel to the line of primaqiune upper piping at a distance of 0.1 cm from this line. The burlap grind off and then cuts her overcast off highway. If the burlap grind-stitching, changing the sequence of processing: first, grind off the burlap and then secured the burlap with woodcarving in the seam of the upper piping primaqiune.
Ready pocket priorivet (Fig. 90). The ends of the pocket put the clips manually or on a special bartacking machine. Frame pocket and fasten slant hand stitches with a length of 1.5 - 2 cm to protect the pocket from stretching.