Materials:

• Knitted fabric of two colors
• Two buttons
• Termolenta

Template:

Here is a PDF pattern for sewing a jumper for a girl 18 - 24 months. Cut into 10 pieces (5 of each color).

Drafting the pattern:

You can also create your own pattern for other sizes. It's pretty easy to do.

First you need to measure the length for the skirt. Let's call this length Du. Now to figure out Дю1 = Du + 1.3 cm
 

Now take a large bowl or plate, put it on paper and measure Дю1 along the circumference. Dot and draw a curved line.
 

Now draw a 3 inch strip starting at top of the curve you made in step 3.
 

Again place the bowl and draw the curve. From below the distance between points should be approximately two times more than at the top.
 

Combine endpoints. It will become a petal skirt.
 

If you make the skirt with uneven hem, draw another line perpendicular to the second curve.

Manufacturer:

assembling the skirt:
 

It is very easy. The convex side of one petal stitch with the concave side of another petal.
 

Keep going until you connect all the petals.

Sewing straps:
 

For shoulder straps, cut two pieces 10 cm x 25 cm If You also use the knit sew, you will have to use thermal tape to the shoulder straps are not slack and does not lose shape over time.
 

To make the belt, fold the fabric in half lengthwise and sew along the long side. Then turn the seam so that it was in the center and sew along the short side.
 

For the bodice, cut three pieces. For the interior lining - cut a piece of 15 cm x 48 cm For the outer part of the bodice cut two pieces of 5 cm x 48 cm and 6 cm x 48 cm

Sew both strips together along the 48 cm side (right sides together). This will make a single two-tone band is 15 cm x 48 cm Fold it in half along the 48 cm side and stitch the short ends.

Fold in half along the inner strip 48 cm side and stitch the short ends.
 

Happened. The bodice is ready to attach to the skirt
 

Turn the skirt inside out and slide the bodice. Align the raw edges of the bodice with the top edge of the skirt. Sew along the edge.
 

Happened. Lay the dress on a flat surface and cut off any uneven ends. Since this is knit fabric, I don't see the need to hem it, but you can finish the hem as you like.
 

To make a jewelry spinner, put thermal tape between the pieces of fabric and glue them iron.
 

Cut squares of 3-4 cm, as shown above. Make diagonal cuts slightly not reaching to the center.
 

Fold the four corners to the center and sew on the seam connecting the skirt with the bodice.
 

Repeat with other turntables.

Sew buttons on straps. Make buttonholes on the bodice.
 

I also added a big fan on the back.
 

While I was busy shooting, a tiny cloud found its way near the dresses and crumbled a bunch of colorful drops.