The quality of the finished garments in accordance with the requirements set GOST 12566 - 81 "sewing. The definition of the grade". Grade determined in accordance with the requirements of the standard and consumer properties of products: appearance, fit, dimensions, and also in accordance with the requirements of the manufacturer, range and the quality of materials, technical documentation on the product the approved sample.
Quality control the manufacture of lightweight clothing is produced at the Desk and on the mannequin. When control of the product on the table first check it from the front then from the back the reverse side. Browsing the product specific sites and areas from top to bottom in this order: collar, bodice, sleeves, skirt.
On finished garments, there are two varieties: I and II. Check the quality of the finished products produced in accordance with the requirements of GOST 4103 - 82, and marking and packing GOST 10581 - 68. In complete products the grade of each product is determined separately and install her part sets (products) of the lowest grade. For example, in the ensemble - dress I grade? jacket grade II, the whole set belongs to the II class, and establish a discount from the cost of the jacket. Ready sewing products I and II varieties is not permitted for the following defects: distortions on the shelves andthe back; the discrepancy between the shelves or excessive set of one shelf to another, tension or excessive planting podborov or upper collar, tension or excessive planting in the ledges of the sides; offset sleeves forward or backward, incorrect distribution of landing of sleeves the curvature of the seams of vrachevanie sleeveless; variance slot (folds) or unnecessary sunset one side to the other; the lack of cushioning parts, provided technical documentation for the product; sharp mismatched colors of thread color of fabric in the outer lines, replacesilk or synthetic thread cotton mismatch the direction of hair on exposed parts of the products; opal.
The product a slight opal in closed units and parts refer to the II class. Products, shortened on the main places of measurements (back length, shelves, sleeves, and skirt length) to a value higher than the permissible deviations of more than one percent of the length specified in the technical product documentation, refer respectively to a smaller increase.
Products oburzenie the big spot size (width of the backrest and shelves or the front width at the depth of the armhole, the width of waist) a value higher than the permitted deviation provided for technical documentation on the product, but does not cause defects external of form and landing on the figure refer respectively to a smaller size or fullness. 
Products very small size and fullness in their oburzenie on the main places of measurements in more than one size refer to the II class.
Product refers to the I or II class according to one or more the defects detected by comparison with the requirements table. 1 GOST 12566 - 81. This table lists the possible production and sewing defects and the magnitude of their deviations permitted for products I and II classes and number of defects permitted in the articles of each variety. 
The I grade will include products not having production of sewing defects or having production and sewing defects under table. 1 standard for varieties of articles I, but no more than three.
By the second grade include sewing products with deviations stipulated in table. 1 standard for products of grade II in the amount of not more than five. 
The grade of the product put on the OTK stamp on the suspended label. Products II varieties have a discount equal to 5% of the value of the product I grade. 
Products with unknown quality of delivery to the warehouse of finished products not be. Product with established grades complement parties and sit on a finished product warehouse where they are sent to the trading network. 
In table. 11 and in Fig. 156 - 177 shows the defects encountered in the manufacture of women's clothing.