Style 53 (see color figure IV) 

Dress of light fabric in solid color or small pattern or cell (sizes 46 - 54), cutting below the waist line. Shelf with a seam in the middle, covered with a plate, which is fastened to the bodice with buttons. Back prilagayutsya. The skirt can be round, pleated, wedges, pleated or flared. Dress is decorated with oblique bakey, sewn to the armhole instead of sleeve, and the lower part of the bodice's hips. Collar - telekrona front with soft pleats at the V neck.

A dress of this style is recommended for young and middle-aged women are not very complete. Women of small stature and complete, you can perform this style in celecration dress pleated, and the bar to cut out to the bottom or 20 - 25 cm shorter. 

Drawing style lines on the pattern (Fig. 187) 

the Style developed by the pattern drawing tselnokrajnimi bodice with short sleeve. 

 Back(Fig. 187, a). From the mid back up to postpone 4 cm, and the height of the sprout 3 cm From point 3 to the left to delay 0.5 cm and place tselnokrajnie rack, as shown in Fig. 187. From the armhole at the shoulder cut to the left to defer the width of the borders (4 cm), and from the obtained point at a right angle to the shoulder cut 12 cm and point 12 is also at right angles to the lines - 4 see Point 4 to connect with the end of the shoulder cut. 

For extended waistline at the side cut from the middle of the back to delay down 8 cm along the side cut the bottom to expand to 2 cm, plotting points to connect. 

 The shelf (Fig. 187, b). Shoulder cut to continue to the right by the width of the rack, i.e. at 3 cm, and from point 3 to defer up half the width of the stand (1.5 cm). Connecting the point 1.5 to the top of the neck smooth line. From the middle shelf on the neck to the left put 2 cm Depth of neckline in the middle of the shelves 10 to 12 cm From the point 10 to 12 right and left to postpone 2 cm to form the mouth of the connecting points of 1.5, 3, 2, 2. To apply a cutting line from point 2 in the depth of the neck to end of shoulder Darts to move it and get the draping on the chest.Extend the waistline at the side cut the middle shelves 8 cm

 Valve. From point 10 to 12 delay down to 4 cm and from point 4 in the other direction to draw a straight line parallel to the top line. The width of the valve split in half and to defer to the right 1.5 cm to Make the Cape of the valve. 

 Strap. Strap width equal to the length of the valve, i.e. 4 cm, and its length equal to the length of the shelves, from the bottom of neck to bottom plus 5 cm to Apply a line of borders at the shoulder cut similar to the back width of 4 cm Length bakey slice on the bottom shelves equal to the length of the segment from the line side of the slice up to the first line of the pulley-block Darts. The width of the borders is equal to the width of the valve in the middle of the shelves, i.e. 4 cm.

The details of the patterns are numbered and show the direction of the grain lines. 

Obtaining the modified pattern and cutting (Fig. 188) 

caused to the lines On the pattern to cut. 

 The backrest (Fig. 188, a) be cut out of the pattern, marking the middle of it to bend the fabric. 

 Shelf (Fig. 188, b). From the depth of the neck lines on the pattern to cut before the end of the shoulder tuck, not dorezaya 0.5 cm Tuck to close, whereby the opening of the new tuck in the middle of the shelves. For more drapery patterns take up 8 - 10 see the Right shelf to find together with the valve. At the bottom of the valve to the side of shelves to make nadziejko 2 cm 

Left shelf to find a valve. 

 For the strap (Fig. 188 in) to carve out two parts of the common thread. In the upper part when cutting to give an allowance for the width of the valve, i.e. 4 cm 

 Bake for sleeves (Fig. 188, d) to carve on the bias thread without a seam on the shoulder, placing the middle of the pattern to the fold of the fabric. On the upper cutoff borders to give allowance for primaqiune to the bodice 1.5 cm Bake on the hip line to carve out a double. Obtachku for treatment of the neck to carve out along with otkroem for valve, once laid the drape. To find a skirt without a pattern. Skirt length equal to the length of the removed measurements plus seam and hem the bottom. Width equal to three circumferences of the thigh plus 3 cm 

Allowance for seams and supplies shown in Fig. 188. 

Tailoring 

1. To celebrate the middle of the back and forepart cushioning seam.

2. To lay a snare for the main lines and shaped patterns. 

3. Baste and sew tackle Darts on the front and the back. 

4. To put the drape in the neck so that the fold creases were in the side of the neck. 

5. To prepare the borders to the sleeve and to the bottom of the bodice. Fold the borders face inward, baste, and sew their ends, to turn out, prometti, priotity. 

6. Baste and sew the shoulder and side seams. 

7. Processing loops at the placket and flap. 

8. Sew the seam in the middle of the shelves and resuturing.

9. To handle the neck and the valve pokrainini obrazkami. To make pokrayney the facing face to the side shelves and back., tack, equating slices, pritchet obtachku, processing simultaneously the valve on the right shelf. To make the notch in the corners of the mouth and the valve. Resuturing the seam, fold the facing towards the inside, releasing the roll from the side of the bodice, and prometti priotity.

10. To prepare the equity bar (item 2), to fold inside out, obtusate, remove the bar on the front side, to iron. Tack bakey prepared to skirt, equating cuts in the waist line. 

11. Fold the bodice and skirt inside out, tack and at the same time pritchet borders to the skirt. 

12. Tack the binding on the armhole, applying her face to the side of the bodice so that the slice borders was in the direction of the openings and fold - in side of neck and pritchet seam width 0.7 - 1 cm, then bend the leg in the direction of the openings. 

13. Processing podkralas the armhole facing.

14. In the middle of the front to sew on buttons according to the location of the loops on the strap. 

15. To attach the bar.