The drawing of the pattern for such a skirt (Fig. 115) must be removed following measurements (in cm):

For all skirts with wedges waist girth and hip girth are recording not half size, and full. 
Before you can begin to build the drawing patterns of the wedge, it is necessary to make a preliminary calculation of the width of the wedge at the waist line and the hip line. For example shestikhino expect skirts all skirts with wedges. 

 The width of the wedge at the waist line. The waist girth divided into desired number of wedges (72 : 6 = 12 cm). 

 The width of the wedge at the hips. To measure the hips and add 4 cm for loose fit, divide this value by the number of wedges (104 + 4 : 6 = 18 cm).
The drawing patterns of the wedge spend a vertical line and mark the point a (Fig. 116). 

 The waist line. From point A to the left and right on a horizontal line lay 1/2 of the width of the wedge at the waist line (12 : 2 = 6 cm) and put the points A1 and A2. 
From point A down the line delay of 0.5 cm and put a point A3. Point A3 connect a smooth line with points A1 and A2.

 The hips. From point A down the line lay 1/2 measurements the length of the back to the waist line (38 : 2 = 19 cm) and put a point B. point B to the left and right spend a horizontal line. From point B to the left and right on a horizontal line lay 1/2 of the width of the wedge at the hip line and dots B1 and B2 (18 : 2 = 9 cm). From points B1 and B2 drop the perpendicular. 

 The length of the skirt. From the point A3 at the vertical lines lay down the measure of the length of the skirt (66 cm) and put the H-point. Through the point N to the left and right spend a horizontal line. The point of intersection with the vertical lines extending from the points B1 and B2, denoted H1 and H2. 

 The extension wedge on the bottom line. From the points H1 and H2, respectively, left and right lay from 2 to 8 cm and dot N3 and N4. Points N3 and N4 connect the dotted lines with points B1 and B2. 

 The side sections of the wedge. Point A1 connect the dotted line with the point B1, and point A2 and point B2. Divide the segments А1Б1 and А2Б2 in half. From points raise perpendiculars, on which lay 0.5 cm the resulting points connected to the points A1, B1 and A2, B2 smooth lines. From point A1 on line А1Н3 delay period equal to the length of the skirt (66 cm), and put a point H5. Point N5 and N, connect a smooth line. In the same way and draw the right side of the wedge. 

 Note. When you cut the wedges, you must consider the measurements of the length of the wedge front, side and rear.