The sleeve on the hunched figure (Fig. 95, a), are based on drawing the sleeves on the model figure. The length of the top part of the sleeves of the model, stooped and pereghibati figures of the same size are the same. However, the sleeve on the hunched figure of the length of the rear portion of the crown Р7О2 on the upper part lengthened in comparison with the corresponding portion of the sleeve crown on the model figure.
The top of elbow reef (point O4) in the sleeve on the hunched figure moved up 0.3 OS.
The top part of the sleeve on the standard figure build in the rectangle, the lower base of which is horizontal. The top part of the sleeve to the hunched figure in building the rectangle, the bottom base which is offset from the horizontal by 0.3 OS. To build the sleeve to the hunched figure build a right angle with the vertex at point RP. From the point RP to the left horizontally lay the width of the sleeve under the armhole and put a point of RL.
At the midpoint of the segment RLC put a point A11.
The radius of the arc О11Рл hold up where you from the point RL on the chord of the arc delay of 0.3 of the OS and put a point R L. Through the points R, l and A11 hold the line, where lay the cut LR R p, is equal to the width of the sleeve under the direct and is the lower base of the rectangle that fits in the top part of the sleeve.
At points R l and R p ostavlyaetsya perpendicular to the line R LR p, on which lay the segments of R and R лО3 PO1 equal to the height of the top part of the sleeve. Points O1 and O3 connecting with a straight line. Cut О1О3 divided in half in the middle and put a point O2.
The position of the point 5 specifies the length of R P5 = Г4П7 (in the drawing the shelves).
Auxiliary point A12 determine the direct part О1О2, i.e. О1О12 = О1О2/2. Auxiliary point Г21 is horizontally drawn from the point p to the right of R (R пГ21 = 0,5 PDS). Point b is determined on the bisector of the angle О1Р'пГ21. The point O4 is on the straight line R of the vines.
ОЗО4 = О3Р'l/3 - 0.5 cm.
The position of the points P6 and P8 are determined on the perpendicular drawn through the point P7 to the line L. OSR Point P2 is determined on a straight PR R l ie R PR2 = PDS. The width of the front roll build contours passing through the points R, p, L, M. the Construction of the lower halves of the sleeves and the rest of the build produced in the usual way.
The sleeve on pereghibati figure (Fig. 95, b) build on the basis of drawing the sleeves on the model figure. However, the length of the rear portion of the crown Р7О2 on the top half compared to the same plot model sleeve decreases. The top of elbow reef (point O4) sleeve pereghibati figure moved down 0.3 of the OS.
The top part of the sleeve pereghibati figure build in the rectangle, the bottom base which is offset from the horizontal by 0.3 OS. To construct a rectangle, which is inscribed in the top part of the sleeve pereghibati figure from point A11 radius О11Рл hold the arc down, at which point RL on the chord of the arc...