Despite a significant increase in the technological design of the pants, the wet-heat treatment of the pants remains one of the most important operations affecting the appearance and shape of the pants.

For processing front halves of trousers each of them is folded right sides inside, combining and equalizing the side and stepping slices. In the upper part staiways section of the bow from a point located below the bow on 5 - 6 cm, to the bottom of his slice. The bend in this area formed a small bulge to the front of the thigh. For combined lateral and stepper sections above and below the knee make the deflection on the outer side and the resultant slack in the front at the bend in the knee region sativum (Fig. 21).

The front halves of trousers can be treated in a different way. Each of the front halves are folded face-up, combining and equalizing the side and stepping slices. Processing produce through procurement, creating a bend (arrows) via the two front halves of trousers. Methods of processing similar to the above.

For the wet-heat treatment of the rear halves of the pants each of the halves is folded, right sides inside, combining and equalizing the side and stepping slices. Ironing is carried out from the line side of the seat. Iron direct from the top of the seat diagonally to the line of the knee, pulling the fabric and creating a deflection from the seat level to the line of the knee. At the same time storevault up the slack. Then iron direct from the level of the knee from. stepper and lateral slices down the side of the bend, creating a bulge in the region of the gastrocnemius muscle. At the same time storevault slack from the line of the knee to the hem.The processing of the rear halves of the pants you can run in a different way, when each of the rear halves are folded face-up, combining and equalizing the side and stepping slices. Processing produce through procurement, creating a fold (arrow) on the rear halves of the pants.