You will need: 

- Jersey, lace (preferably narrow), ribbon made of satin. 

Parts cut:

- one part with the bending of the upper and lower parts of the back of the top;

- the two parts of the upper part of the front of the top;

- one piece fold the bottom part of the front top; 

two parts for upper and lower sleeves;

one detail for the piping of the neck back and the two parts of the piping of the neck front top.

Allowances:

- ACC bottom of the top half an inch;

on the slices, one centimeter;

- cut parts of piping – half a centimeter. 

Job description:

Sew tuck detail on the front and zautyuzhte them to line up the middle of the front. Details of the back and front of the top handle is cut earlier obrazkami.Sostrochite the product at the shoulder seams. At the same time grind down short cuts obrazek back and front. Run side seams of the top parts, investing in wide satin ribbon on each side just above the bottom the cut parts. The top part of the front slightly overlap each other, and after fasten with a few basting stitches. Sostrochite the bottom part of the top of the side seams. Sew to the top part of the productits lower part. Sew together upper and lower parts of the sleeves. The seams on the sleeves close with satin ribbons. Sew seams of the sleeves, capturing the short edges of strips. Sleeve vmlite, and after vsheyte in the openings. On the bottom the sleeves and the garment sew narrow lace trim at side seams tie the front into a bow.