Wet-heat processing of the product. Before connecting the jacket with the lining of the wet-heat treatment is performed in two steps. First priorivet regional areas, starting with the left side shelf (side podborta), then hem the Board and right shelves; finish the first reception priduzivanja lapels with side shelves (first left and then right). The second reception priorivet jacket on the reverse side starting with the right shelves. Priorivet the upper part, fixing the jacket's shape in the chest, then his pocket and bottom shelves. Next, move on to prutivka back and left shelves.The entire wet-heat treatment on the reverse side of the product produced by steaming, drying and fixing of the dowry forms. Wet-heat treatment can be performed by means of an iron or press.

 The connection pads with the product. The details of the lining of the jacket and the coat is cut similarly. The connection pads with the product depends on the method of treatment of the collar: when processing obecnym collar seam connecting the lining with the product after connecting the collar with the neck; during the processing of a collar, and tucking sections to departure and the ends of the lining is recommended to connect the product to the grinding of the shoulder sections. The first method is specified in Chapter 1, p 16. In the manufacture of jackets, often used the second method of connection of the lining with the product.This method involves various methods of attaching linings: manual, combo and machine.
In the manufacture of products for individual orders more frequently used combination method (machine and hand). In this method, the lining sew the Darts and side sections of the seam 1 cm wide, iron the seams in the back side, the back seam do not grind off. Before connecting the lining with the top of the product specify the length and width of its top products, providing necessary allowances for processing, the excess lining trimmed.
The connection of the lining with the jacket combined method is the same as in coat (see chap 1, p 16). Feature is the grinding medium slices back lining after connecting it with the product on the sides. For grinding medium slices back lining both shelves clean inside, folding the two halves of the back face, cuts equalize and grind off the seam width of 1 cm In jacket side seams of the lining are not allowed to attach. 
After screwing out of the product on the front side of the lining namachivajut as described above (see Chapter 1, p 16).
To check and trim lining on the bottom turn the product face up bottom to bottom running and check the correctness of connection of the lining with the top of the product. The excess lining at the bottom of the cut, leaving 1 - 1.5 cm from the edge. Product turn lining up, tuck the lower section of the lining inside at a distance of 1 cm from the edge, zametyvayut at a distance of 1.5 - 2 cm from the fold straight stitches with a length of 2 - 3 cm seam Allowance of the lining hem and folded hem blind stitch line loop-like stitches with a frequency of 3 stitch 1 cm.
The most progressive method is the connection of the lining at the bottom of the jacket by machine. To do this, the bottom corners of the boards should be processed as described above (see Chapter 2, p 6).
Before connecting the lining with the product should be handled tuck, medial and lateral joints. Lining pritachivajut to the inner sections of podborov along the entire length, as described above. For protecive lining on the bottom turn the product inside out and equalize the lower sections of the lining and products. Primaqiune are lining seam width of 1 cm, starting from the inner edge of the starboard side up to the edge of the left.Before screwing out of the product on the front side of the lower sections on the plot side strip, side seams, reliefs, medium seam of the back attached to the seams allowances of the top slanted stitches. Then, after screwing out of the product on the front side of the fastening seams of podborov and namachivanija lining is produced as described above (see Chapter 1, p 16).