To their hands to sew the head capes Cemar, which serves as a substitute difficult to tie a scarf, you do not need to have any special tailoring skills, as this thing is sewn quite simple. The most suitable fabric for head wraps is a thin white cotton, but, if you wish, you can always substitute for wool, viscose or knitted fabric. There are several embodiments of this product. Today we will consider them.

So, the essence of the first method is as follows. Acquired desired the fabric, and you have to take in 2 widths, that is, if you have a piece of material with a width of 1.1 m, you should take the 2.2 m. the Cloth is folded in half. Bend, which you will, will serve as the top of your head wraps. From the fold down edge is delayed about 27 to see If to speak more precisely, this value should be half of the measured circumference of the face. Then laid a bead on the upper end of which is a very solid hook up.To finish tailoring and get the finished product it only remains to handle the lower section of kimara.

Now go to the second option. From a material width of about 1.15 m you can always sew a poncho that will protect you to the ends of the fingers or wrists (it will depend on your height). For kimara purchased 2.5 m of matter. It is desirable that it was light and soft cotton. In addition, it would be nice if the fabric stretches a little. Great fit and knitted fine cotton cloth, which are sewn t-shirts. You can also use a silky polyester (light).

The fabric width is folded in half with the fold at the top. While the front side should be inside. In that case, if the fabric is a little bit slippery, commit it in several places with pins (this will prevent possible displacement). Then on the planned gentle curve is cut off the excess fabric. The beginning and the end of the line must be drawn parallel to the sides of the material. Due to this, the front and back of the head wraps will not V-shaped and straight. For design front kimara need to put down from the fold of the fabric 23-27 cm along the edge.Then you proceed to the front seam, leaving the face nezastroennoe area. The lower cut slit for face kimara be processed with braid (lace or decorative).