Dress in fabric in small cells, soft shape, long sleeves, waist cutting (Fig. 15). 

Flirty together with valve pockets cut in an oblique direction of the thread. In the middle of the front placket fastened by buttons. Turn-down collar small. The skinny belt is passed under the diagonal bar. Skirt video. 

This style was developed on the pattern of the bodice with cap sleeves and gusset.
 

Drawing style lines on the pattern 

 Front panel. Applied to the pattern width of the yoke, defining which part of the shoulder width it occupies. For example, the yoke is 1/2 of the shoulder width, then the pattern width of the shoulder, divide in half and draw a shaped line on the pattern. Shoulder tuck move into the carved line of the yoke.

At the time of closure and making straps from the depth of the neck to the right set aside 3 cm. From point 3 draw the line parallel to the middle of the front cloth of the dress to the hem. For design of strap from the middle of the front of the chest to the left set aside 3 cm. From point 3 draw the line parallel to the first line. From the chest in the middle of the front aside the length of the valve, that is, 7 cm, and decorate it any style. 

 The design of the yoke. Combine half the width of the shoulder (point 2) with the width of the valve (point 3) smooth line (Fig. 15 b).

Traveling tuck should be applied at the cut of the pocket to tuck end to combine with leaflets. 

Place a pocket of any shape can be found by means of calculation. To do this, measure the length of the back to the waist (DST) divide by 4 plus or minus 1 - 2.5 cm depending on style. 

 Collar. Construct a rectangle equal to the semicircle of the neck plus 1 cm, 19 cm, width 7 cm Lengthen the collar by 1 cm on the unfastened parts.

The size of the collar, belt, pockets should be consistent with the size of the dresses, therefore, for each size you want to increase or reduce the size of the shaped line of the collar, pockets, straps on 0,1 - 0,3 cm

Obtaining the modified pattern and cutting 

 the Rear panel. If there is no style lines, to cut out without modification. 

 The front panel. Cut the pattern on the contoured lines on the parts (Fig. 15). At the lines cut the yoke along with the valve. The shoulder dart is closed and moved to the carved line of the yoke. When cutting the pattern yoke fold the fabric in half, aligning the fabric. The direction of the common thread (B.) on the pattern is compatible with the direction of the grain lines on the fabric. The left part of the yoke cut without valve. One detail of the bodice is cut on the twice folded tissue. The middle shelves and the middle of the front cloth of the skirt is put to the bend of the fabric. The bar cut on the bias yarn, put the pattern to the fold of the fabric.

Before you begin to reveal a developed style, you need to check the position of the lines, the shape and size of the parts or change them at will (reduce or enlarge). After verification, proceed to cutting the fabric.