Winter coat for girls 6 - 7 years straight silhouette, slightly expanded at the bottom line. Finish - fur Mouton at the bottom of the sleeves, hood and hem coat. Patch pockets with flaps and yoke trimmed with embroidery art surface. Closure with four buttons. Coat can be sewn from thick fabric or drape. 

On the main pattern coat for girl apply a line style coat. In this model, the line style is a round yoke and patch pockets with flaps. Under the yoke to the pocket - tuck. Sleeves, double seam, set-in (Fig. 79, 79 a). 

 The layout on the fabric. The pattern of the front being cut on the lower line of the yoke and the tucks. Pattern the middle of the back and front affixed to the fold of the fabric at common thread. Little details - the yoke, pockets, sleeve disposable between the major parts common thread. 

 Gain on the joints in the neck - 1 cm at the shoulders, sections, side seams and hem of sleeve - 2 cm, bottom coat - 3 cm, neckline - 1.5 cm

Hood 

To build a drawing pattern of the hood (Fig. 80) must be removed following measurements (in cm): 

1. Length from the forehead to the cervical vertebra - 32 

2. Head circumference - 48

Draw a right angle with vertex at point A (Fig. 80). 

 The width of the hood. From the point A to the right put 24 cm - 1/2 measurements head circumference - and the point A1. 

 The length of the hood. From point And put down 26 cm - 1/2 measurements head circumference plus 2 cm for all sizes - and the point N. From point A1 down put 32 cm - measure the length of the hood and put the point H1. 

 Tuck and the line terminations of the hood. Points N and N1 connected with a dotted line. From the point H1 to the left put 5 cm and the point H2. From point N to the right put 8 cm - 1/3 of the width of the hood and put a point 8. From the point 8 to the right put a 2 cm Segment from point 8 to point 2, divide in half and through the point of dividing up put 7 see points 8 and put 2 up for 1 see Line terminations draw through the point H 1 and 1 H2. Points 1, 7 and 1 join. 

 The front line of the hood. A1 point is connected to point D2. The area of the hood you can round (point A), but you can leave a sharp corner.