Before you start Ironing products, you need a piece of cloth moistened and ironed, checked, whether there will be stains on it when wet. If no spots, it can be the product of a thin fabric Ironing inside out without pads (moistened linen cloth). If stains remain moisture fabric, Ironing the product carefully. To do this, moisten the seal, squeeze, put it on the table and hold a hot iron, removing part of the moisture, or the wetted pad to put on a dry cloth unfolded and rolled by the roll, the moisture will absorb, dry cloth.
Products from silk, nylon, chiffon, velvet to iron it with a hot iron without moisture.
Pressing Darts. In the products of woolen and heavy fabrics tuck should priotity to the edge (along the fold). For ease of stroking to put a shelf underside up so that the shoulder cut was located to the right hand. Slightly priotity shoulder tuck, starting from the shoulder cut to the end of the tuck. Remove the basting and continue Ironing until it is tight tuck.The resulting slack of the fabric in the tuck end sucurity, stroking traveling tuck turn the shelf so that the slice was located to the right hand, priotity her gently, starting from the outlet to the tuck end, remove the basting and continue to iron until it is tight.
Traveling tuck bodice and skirt to press towards the middle of the product.
Shelf shoulder sections to put to yourself and to iron the side from the armhole to the center of the bulge tucks, satwiwa slack in the armhole and the Darts on the ends. The slack fabric on the chest to press, putting a shelf cut in the waist to him.
Then put a shelf so that the shoulder cut was in the right hand, and Ironing, starting from the neck to the bottom, then turn the shelf side cut to yourself and ironed sidewall, giving the shelf a finished look.
If degree which the contour lines tuck imprinted on the front side, that is a Lassa (glitter), to remove them you need, from the inside out, lifting the tuck, put the wet pad, to steam to remove the Shine.
Properly pressed product gets a good view.
| 