Materials:

• half meter of tulle fabric with hearts
• a quarter of a meter white knitted fabric
• half meter of black knit fabric
• one meter of black ribbon

Estimated time: 2 hours

skill Level: average
 

1. To use an existing garment to draw a pattern. In my case I wanted the dress was little more than a t-shirt I used, so I left a little seam allowance (2 cm).
 

2. Here is the top detail which I did. Now do yourself a favor and draw this piece to a newspaper or any paper. Next time you faster and easier to make a dress or t-shirt.
 

3. Now dragging the armhole to cut out sleeves. For the sleeves, I used the hem and I didn't have to hem the sleeves.
 

4. Here is the pattern resulting from you. Now it is obligatory to change these hoses on the paper too.
 

5. Now we need to cut our tulle for the chest. For this you need to cut 2 pieces 7,5 cm x 35 cm of tulle.
 

6. Now increase the tension on your sewing machine and set stitch length to maximum, also set the speed to maximum. Now sew the row center the entire length.
 

7. Now take two strips. Place them on top of the stitches you just made. To reset the machine tension and stitch length. Now sew the ribbon over the stitches.
 

8. Sew the tulle ruffle on the front.
 

9. Sew the side seams and sleeves. To sew sleeves to the shirt. Tie, tie the ribbon in a bow at the front and cut off excess ribbon.
 

10. Cut a 7.5-inch-wide strips from the coordinating fabric (incl. white in our case). Width white fabric one and a half times greater than the width of the shirt.
 

11. Now cut the tulle the same size piece.
 

12. Stitch the short ends together, like tulle and white fabric. Insert the white fabric inside the tulle. Now you have a skirt that has hearts on the outside and white knit on the inside.
 

13. Re-install in the car mutagennosti to the highest, stitch length to longest, the sewing speed max and sew along the long sides of the skirt. This will ruffle the fabric, turning it into the Assembly.
 

14. Manually align the Assembly with the width of the t-shirt. Now pin the skirt to the shirt and sew.
 

15. I the hem of the dress was not processed because the tulle and knit does not fray. However, you can, if you wish, hem hem.
 

16. For the neckline I cut out strips 5 cm wide and two third of the neck in length. We are going to sew this strip, stretching it across the neck so that it does not become wavy.
 

17. Stitch the short ends together (right sides together). Now sew the binding strip to the neckline, gently pulling her along the neckline.
 

18. Fold the raw edge of the neck is sure to yourself and secure it on the inside (like with bias tape). At this stage, be careful. The neckline is the most noticeable part of the dress, and You don't want to look scruffy.
 

19. Take care of securing the tie with ruffles inside the neck.
 

New dress for Valentine's day!