On the basis of heats you can simulate shorts, short pants, Bermudas, Capri, etc. (Fig. 157).

The drawing patterns of the bottoms will need the following measurements (in cm):

1. Poluobhvat hips — (PSP) (30).

2. The length of the product, which can be calculated as follows: DI = POB : 2 + 11 = 30 : 2 + 11 = 26.

The front half. The drawing of the pattern melts, and the drawing of patterns of other products, begins with a right angle. On a prepared sheet of paper, draw a right angle with the vertex at the point A.

Line the middle of the heats. Down from the point And put the measure DI (26 cm) and put a point. An line would be the line of the middle of the heats.

The waist line. To hold the waistline, to the right of the point And set aside half of the measurements of POB plus 3 inches and place point D: AD = POB : 2 + 3 = 30 : 2 + 3 = 18 see

the bottom Line of the bottoms. To the right of the H-point parallel to the line AD draw a straight equal to 18 cm, and put the point H1.

Making the side cut of the bottoms. Connect the points D and D1 straight, divide it in half, add 1 cm and place the point D1: DD1 = DI : 2 + 1 = 26 : 2 + 1 = 14 see

step Width and the cutout for the feet. To the right of the point N put 1/10 POB measurements and set point H2: НН2 = POB : 10 = 30 : 10 = 3 cm

Obtained point connect point D1 with a straight line. Then direct Н2Д1 divide in half and put a point D2, from which at right angles to Н2Д2 draw a straight length of 2.5 cm, a dot D3. Points D2, D3, D1, connect as shown in the drawing.

The rear half. A drawing of the back half of the heats build the same as the front but a little longer, that is up from the point And put 2 cm and mark the point D. This point connect a smooth line with point D, and the pattern will be ready. To cut out trunks, the fabric is fold in half. Carefully cut out the pattern and place on fabric (Fig. 158).

Transferring the pattern to the material, mark the seam and hem the upper edge of the bottoms, whose width should equal the width of the elastic plus 1 see Cut parts of the bottoms and sew them up. First, sew the side seams lapped seam. Then treat the cut outs for the legs with oblique piping. For this obtachku sew the face to the underside of the bottoms, fold it on the front side, straighten and baste the seam, releasing the roll of piping. Then cut the piping to hide inside, and stitch at 0.2 cm from the fold.Allowance left for filing the upper edge of the product inside out and fold gently prometiste. Then the edge of the seam allowance clean inside and stitch at 0.2 cm from the fold, leaving nepostroennye 1 cm to pull the gum.

Concrete driveways Hamilton