Machine 22-A CL. PMZ (Podolsk mechanical Zavod imeni M. I. Kalinina) is used for grinding of clothing from suiting and overcoat fabrics medium weight. The machine has a rotating Shuttle and is found in process streams in several variations: machine 22-B cells. - for grinding of clothing items out of thin light fabrics; machine 22-In class - for grinding tissue with simultaneous trimming of the seam (machine with a knife).

The speed of these machines 3500 rpm. the Largest stitch length 5 mm, average power consumption of 0.15 - 0.2 kW. Pulley diameter of 60 mm. Machine is equipped with a special mechanism to change the direction of advance of the fabric to secure the stitches at the beginning and at the end of the running suture, thereby increasing productivity. The machine has a device for winding thread on the bobbin (winder). 

 The car is a 97 CL. OSL (Orsha factory of light engineering) - fast, powerful technological applied on threads for sewing clothes, dresses, suits. Speed 5000 rpm; this makes it possible to separate operations (under the long seams and finishing lines) to increase productivity by more than 10% compared to the operation of the machines 22-A CL. PMZ. Stitch length to 4 mm. 

the Machine has centralized grease Shuttle and some parts of the mechanism promoting tissue. 

 Machine 597 CL. OSL with needle deflection along line - for grinding of clothing items of fabrics with synthetic and chemical fiber two-line non-stop Shuttle line. The machine speed 4500 Rev/min. 

 Machine 697 CL. OSL - speed, designed for grinding clothing of light fabrics with synthetic fibers. The machine has a differential feed, providing non-stop seam. Speed 4500 Rev/min. 

 Machine 797 CL. OSL - for connection of details of clothes from lightweight fabrics with simultaneous cuts buttonhole stitches. Stitch length up to 4.5 mm, the distance from edge to stitch up to 8 mm. the Machine performs stitches: sanding - two-line Shuttle and blanket - twin chain. Speed 4500 Rev/min.

The use of sanding machines with high speed it is advisable not only for the execution of welds of great length. For the machining of pockets, sleeves and other details of these machines enable the economic effect is expressed in reduction in operating costs: reduced costs for repairs and maintenance significantly increases the service life of the machine.