Graviola product is put on the customer, joint shear pins cut zipper in the middle front of the neck, on the lines of bust, waist and buttocks. To avoid displacement of the product relative to the figures, it should bepin to the underwear front and back waist and accurately set waist line. This figure tightly encircle the tape and thus determine the correct location of the waist line. The braid needs to lie flat. Line ribbon pin pins. The fitting is performed using the pins on the right side of the figure, if the figure is largedeviations from the relatively proportional (e.g. one shoulder higher than the the other, uneven hips, etc.)
then on the left side. During the fitting I specify the direction of the grain lines on the details. 
A fitting beginning to test and Refine the balance of the product.
Cutter drew attention to the fit of the product to fit customer, how the product fits to the figure in the region of neck, shoulder seams, along the lines of the chest, waist and hips, clarifies the position of the shoulder seam line which should be in the middle of the shoulder and side seam. The slightest changing the position of the shoulder seam entails a change of position side seam. After the correction of the balance of the product cutter says the depth, direction and length of recesses, undercuts, reliefs and folds,the depth and width of the neck. Tuck the top regardless of itsthe location on the model should be directed to the center of the chest. Neckline neck specify, in accordance with the model. If at neckline formed slack (fold), neck slice netscout a few places and plan a new line. The collar is attached to the product so that its middle coincides with the middle of the neck.
You should pay attention to fit products on the armhole, and if necessary increase landing back at the shoulder seam, the size of the openings or stivania deepening the openings to make the notch for deepening the armhole and mark the landing place or stivania. 
In the refinement of the product line waist check first if the waist and normal length and the depth of the Darts, at the expense of increase which you can get more a snug fit of the appliance to the figure at the waist, and by reducing solution, on the contrary - more loose fit.
In the refinement of the product line of the buttocks to check the position of the side seams and creases.
Then specify the length of the product from the front, side and rear (from floor by means of the special adaptation or a ruler). Fitting sleeves produced after clarification of items on the figure. The cut of the top part of the right sleeve bend towards the inside by 1.2 - 1.5 cm and pin it the product, combining the highest point of the top part of sleeve with shoulder seam, and the second and the third pins fixed landing lifts the shoulders at the top, then specify the line of the armhole of the bodice and put identification marks in place of pins on the sleeve and the armhole of the product, specify the width, the sleeve length and its positionregarding the seams. The cut of the hem, sleeves, patch pockets and other finishing details that bends towards the inside and fix pins.
When fitting dress-suit first try on the skirt and then the jacket.