The bottom of the pants, depending on the model, can be uncuffed, with double cuffs and banded cuffs or treated with wood stains. 
  Handle the bottom of the pants with double cuffs. To clarify the cuffs and hem the pants laid out on the table right half up, combining a stepping and side seams, equating edge clasp. On the auxiliary pattern outline cut lines bottom and treatment cuffs.
In the manufacture according to individual orders right half of the pants are folded from the middle seam at the inseam lay measure the length of pants inseam and pursuing a line of bending the bottom"thendown at a distance equal to twice the width of the cuff in - the second line and at a distance of 1 - 3 cm from the trim line down.

The right half of the pants is applied to the left and transferred to her chalk line. Bottom of pants are cut on the bottom chalk line. The chalk line transferred to the outside of the pants. Then the bottom of the pants bend inside out cut edge bends inward and zastrugivajut on the sanding machine or sew on the machine concealed stitches (Fig. 108). The bottom of the pants priorivet. 
The cuff turn on the front side and attach along the side and stepping seams, hand or machine. 
Cuffs ready priorivet. 
  Processing the bottom of the trousers without cuffs. To clarify the pants laid out on the table right-half up, combining stepping and side seams, equating the edges of the zipper and the top hem andstraightening middle seam. 
On the auxiliary pattern specify line bending and trimming the bottom. The bottom cut, then bend inside the the planned line, the cut of the hem bends inward (Fig. 109, a) and sutured on a special machine; overcast on a special machine or zastrugivajut cut on a sanding machine and sew on the machine concealed stitches (Fig. 109,b).
For stability bend the bottom of the pants use the gasket from proklamelin. The gasket is applied from the inside halves of the pants an amount not exceeding the width of bending the bottom. Bottom of pants can be processed by Beek of basic or finishing of the fabric. The processing of the bottom of the pants wood stains perform similarly, as shown in Fig. 16 b. 
  Processing of the bottom of the pants with banded cuffs. At the bottom of the side seams in the pants with banded cuffs should be provided with cut - slots. Edging the edges of the allowances for processing slot treated with suture itagiba with a shut cut or seam with bodybu serged the cut.
Depending on the model of the pants on the bottom lay the folds, or gather the Assembly. 

Cuff (inner side) pritachivajut to the bottom of your trousers from the trousers. If Assembly on the bottom of the form with the help of special legs simultaneously pritachivajut cuffs, primaqiune perform with hand cuffs, bending the edges of the slot from the front of the halves inside the line continuation of the side seam (Fig. 110,a).
Laying the folds and the formation of assemblies at the bottom of the pants performed simultaneously with pritachivajut cuffs. The folds are bent towards the side seams. Then produce grinding of the ends of the cuffs in extension of the edges of the slot, at the same time turning equity sections of the cuff towards the inside of 0.5 - 0,7 cm.
The ends of the cuff turn on the front side, angles correct. Cut the cuffs from the front side of the pants tuck inside and scribbled at a distance of 0.1 cm from the bent edge, covering the seam primaqiune the inner part of the cuff. The upper ends of the slot fixed cross stitching simultaneously with the grinding of the side cuts (Fig. 110,6).