Caps. Cap 1 (Fig. 127 a). Consists of base (Fig. 127 b) and the bottom (Fig. 127). Finished with a ribbon lace. First, a strip of cloth cut on the bias, around the long side of the base. You need to pre-tack sobornuy tape. Tape can get out from under the bonnet (Fig. 128 a) or placed on the base of the cap (Fig. 128 b). The base is connected to the bottom, on the base side applied finish-cut edging (Fig. 129).
 

On the bottom slice of the bottom lay the clips fix. The bottom can be decorated with ribbon or strip of edging. On each side on the bottom left 20 - 25 cm for drawstring. Part of the low edging, strips of the tie aligned and fixed simultaneously with fastening of the edging on the bottom (Fig. 130).

All the seams in the cap is placed on the front side, so as not to inconvenience the child. It is undesirable to finish the whole bonnet ribbon, as it is not as flexible as oblique stripes, and can pull all the lines.

  Cap 2 (Fig. 131 a). Consists of two lateral parts (Fig. 131 b) and one intermediate (Fig. 131). Finished with lace or ribbon. First, to the side or middle part lace primetyvajut, then connect the rounded part of the sides with the middle part. In this case, the wide side goes to the forehead, and narrower to the back. Smatyvay seams and edging strip (Fig. 129). Then enclosed the outer side, also putting a lace (Fig. 128 a). On the bottom cap sheathe more a long strip, so that at the same time make and tie (Fig. 130).At the sides you can sew the ribbons on one or both sides. For this, harvest a strip of edging with a length of 12 cm, folded three times and scribbled in the right place (Fig. 131 g).
 

The cap 3 (Fig. 132 a). Consists of a single part (Fig. 132 b) and going in a circle on a tape or braid.

The same scheme can be stitched and a summer hat. First seam to hem handle the cut of the bottom (tuck 0.5 cm, then 1.1 cm, fixed line). At the outer edge of the slice is enclosed (Fig. 132), on thin fabrics it can be trimmed with a twist (Fig. 132 g). This bends of 0.3 - 0.5 cm on the wrong side and make small zigzag stitch. From the inside sew the strip cut on the bias, a width of 2.5 - 3.0 cm, so that in the finished form this detail, performing the role of kuliski, was width 1.2 - 1.5 cm depending on the tape width.At the same distance from the edge sew a drawstring, superimposing her face on the underside of the bonnet. The second side bends on 0,6 cm and sewn at the top (Fig. 132). Then prodelyvat braid. When nastraivanie the second side of the drawstring, you can immediately attach a braid or ribbon for the drawstring (Fig. 132 g). The length of the ribbon take enough to, lay the cap flat you can iron.