Worked on the figure design straight skirt is the basis for modeling wide skirts, skirts pleated, skirts with different accents - ruffles, pleats.

7. Skirt yoke in crisp silk flared, with decorative flounce on the front panel. (Fig. 186, Fig. 20).
 

The design shown in Fig. 186. On the front and rear panel note the yoke line, this line is cut off and lay on paper tuck top cut line aligned on the bottom slice add 1.0 cm to the seam. On the bottom of the front and rear panels outline on paper, lines lined, cut, short by 3 to 4 mm to the upper edge, then push to the desired value, in this case 6 to 7 cm between each strip. Then the lower section down a smooth line, outline the top slice and add 1.0 cm to primaqiune to the yoke.Make sure to check the length on the bottom yoke front and rear panels and through the upper cut of the wide part of the skirt, they should be the same, to align the sides of the panels can be added or taken away (Fig. 186 green dotted line). The items received for ease when cutting, it is desirable to make a copy on paper. The warp yarn passes in the resulting parts as in a straight skirt. Finishing the flounce is constructed on the front panel (Fig. 186 6).Since the shuttlecock is much wider than the front cloth, the line of the flounce is applied on the front panel, cut out, causing the line of cut for sliding (black dotted line), the bands widen to 3 - 4 cm Top and bottom sections of flounce draw smooth lines, check the length of the upper slice, if necessary, added to the side (green dashed lines in Fig. 186 b).

Processing features: flounce hem and front hem cut seam to the hem, then primetyvajut at the top and side sections to the front panel, connecting the side seams. Yoke back and front panels connect to right side, left side seam do not grind off entirely, leaving a part unsewn for zipper, yoke connecting the webs, stachivaya zipper and prostrachivajut zone. The length of the belt equal to the circumference of the waist +5.0 cm to the processing width upon request, for wide belts required thick padding, so it is not minimized.
 

8. Flared skirt made of cotton fabric at the yoke with a zipper in the center on the front (Fig. 187).
 

The details of yoke and panels, as in the skirt 7, however, amends the yoke front cloth (Fig. 187 a). It is the center cut, adds 2.0 cm to the clasp and 4.0 cm ACC. For strength of closure for the ACC provides for the strip (Fig. 187 b). Belt are longer than the ordinary skirt, it is equal to the circumference of the waist +11.0 cm in length coquettes and processing. Sew the side seams of the panels, the side seams of the yoke, the yoke prostrachivajut belt, on the right yoke front cloth stitch with length equal to the diameter of the buttons +2 mm.If the buttons are large diameter, there should be a ACC greater than 4.0 cm Right yoke namachivajut on the left and sew round to the back and front panels. The bottom hem seam to the hem or manually cross stitches, iron the skirt and loops at the left yoke stitch buttons (Fig. 187).