11. Straight skirt with pleats on the front panel of wool fabric (Fig. 190). Consists of the back (Fig. 167 a) and front panel, lateral part of the front panel and insert under folds (Fig. 190 a). The front panel on a line parallel to the tuck warp is cut at cut lines to it and to the lateral part provide an allowance of 1.0.
 

Further development is conducted on the side: there is a line podraza (depending on the width of the insert under the fold in the finished form and the number of folds) is extendable insert under folds across the front of the slice taken into account seam 1.0 cm, side 1.5 cm In this case there are three pleats with a depth at 5.0 cm Distance between pleats 6.0, seeTo display a line of the upper edge of the insertion, you lay planned on paper folds and shear their pins, then apply a line on top of the insert ready, adding from about 1.0 cm to primaqiune belt, cut along this line and folds to reveal, get curved. Direct undercuts this line will be straight as on the bottom.

On the bottom cut side part gives the seam 1.0 cm. For the basting lay the folds, priorivet, then they must be pristroit to the lower cut on the sides. If required, the finishing line, the suture is directed upward and make the line at the sidewall. Sew the tuck on the front panel and attaching the side pleats to the front panel. No further processing differs from processing a straight skirt.

12. Straight skirt made of wool or polyester with pleats at the rear panel (Fig. 191). Consists of front panels (Fig. 167 6), two side parts of the rear panel, middle section and insert under folds (Fig. 191 a). The rear panel is cut along the line recesses and parallel to the warp threads along the line of the cuts give an allowance of 1.0 cm from each side. The middle part is cut horizontally on the level of the desired length of the folds.
 

In the middle of the insert under the fold (Fig. 191 6) is an inverted pleat, the rest of the folds toward the center of the depth of the folds of 5.0 cm At the sides and the top slice insert under the fold given the seam 1.0 cm. Sequence of treatment: lay the folds at the inset, priorivet and pritachivajut to the middle part of the rear panel, connect the side parts of the rear panel. Further processing is similar to processing a straight skirt.