Treatment back Trouser pocket with flap. To handle the rear pocket (Fig. 255 a) requires the following details: valve of the main fabric - 1 detail lining the valve body 1, the facing of the main fabric - 1, the Hessian of pocket tissue - 1, the valance is made of lining fabric -1 detail.

One end of the burlap is applied to the underside of the rear halves of the pants so that it crossed over the chalk line of the pocket of 15 - 20 mm, and primetyvajut.

The valve is applied to the front side of the rear halves of the pants face down, with the processed edge to the upper slice, combine the planned line on the flap and on the rear half and primetyvajut stitches with a length of 10 mm. Pritachivajut valve to the back half of the trousers at a distance of 1 mm from smachivaniya. Thread smachivaniya removed the seam folded in the direction of the valve. Butt to the seam of primaqiune valve facedown stack obtachku, primetyvajut and pritachivajut to the distance between the lines of primaqiune valve and piping was equal to 3 to 5 mm.

The correct primaqiune valve and piping check from the burlap. Lines of primaqiune valve and piping must begin and end at the same level. Seams rautureau. The pocket opening is cut from the inside, beginning from the middle towards the ends of the pocket. If the distance between the lines does not exceed 3 mm, the cut performed to the end in a straight line. Through this orifice, the facing is turned inside out, forming it from Kant, in width equal to the distance between the lines of primaqiune valve and piping. Kant fixed machine stitch the seam below primaqiune piping 1 mm.

The inner section of piping bends 5 mm and scribbled on the burlap at a distance of 1 mm from the bent edge. Then the burlap bend so that the free end reaches the upper edge of the rear halves of the pants, and the outline and the fold line of the cut pockets on the burlap.

In accordance with the intended line of the cut pocket on the burlap impose the valance lining fabric lower section valance bends 5 mm inside and scribbled at a distance of 1 mm from the bent edge. The burlap grind-stitching. First burlap valance with turn down and sew the seam width 4 mm. then turn the burlap, the edges and corners straighten and grind off a second time at a distance of 5 - 6 mm from the edge. Seam primaqiune valve straighten and pritachivajut to him at a distance of 1 mm or seam primaqiune valve from the burlap (Fig. 255 b) the second end of the burlap.Primaqiune performed from the front side.

The ends of the pocket put the tack. In the finished pocket priorivet from the inside and from the front side, straightening the irregularities of the valve and the bottom edge.