For the drawing of the pattern , clear the following measurements:- poluobhvat neck, chest, and hips, length of waist, back and front, length sleeves. 

DRAW THE PATTERN OF THE BACK. At = measure the length of the back plus 3.5 cm, HS = 18 cm, AA1 = НН1 = 1/2 scoops of poluobhvat chest plus 4 cm AA2 = 1/3 poluobhvat neck plus 1 cm, AA3 = 2.5 cm, А1А4 = length sleeves, А1Г = 1.2 poluobhvat chest plus 3 cm, ГГ1 = А1А4 short sleeve А₁4,4. From the G to the right and down 4 cm Long sleeve and 3/4 sleeve - from A1 to the right set aside 25 cm and lower the dotted line, the point T1 connect with the end of the dotted line. 

THE CREATION OF THE DRAWING PATTERN OF THE FRONT. Al = the length of the front plus 1 cm, HS = 18 cm, AA1 = НН1 = 1/2 scoops of poluobhvat chest plus 4 cm AA2 =1/3 poluobhvat neck plus 1 cm, AA3 = 1/3 poluobhvat neck plus 3 cm, АА4 = 1/3 poluobhvat neck plus 2 cm, А1А5 = length sleeves, А1Г = 1/2 poluobhvat chest, and Т1Н1 GT1 = GT, and Т1Н1 with drawing back. ГГ1 = А1А5 short sleeve - A1,4,4. From G to the left and down 4 cm Long sleeve and 3/4 sleeve from A1 left aside 25 cm and lower the dotted line, the point T1 connect with the end of the dotted line.To calculate the blouse at the hips add to the standards of poluobhvat hips 2 cm, from the result subtract the sum of the distances between the points N and N1 on the back and the shelf. The result is spread evenly between the back and the shelf and put H2.

CUTTING. The blouse can be made without a seam in the middle of the shoulder and sleeves. In this case, the pattern of the back and front attach to the fold of the fabric, aligning them at the shoulder sections. Seam do not. If in the middle of the shoulder and the sleeves you want to make the seam, the sleeve can be made more sloping. From A4 down put 10 - 12 cm on the back and 18 - 20 cm on the shelf (Fig. these lines are shown in small dotted line). If you want to make the sleeve wider end of the hose connect straight to T1 (Fig. these lines are shown in large dashed lines). This pattern can make the dress - extending the drawing to the desired length.

In Fig. 1 blouse, neckline and cuffs trimmed with lace. 

Fig. 2, blouse with short sleeves and a gathered shoulder. 

Fig. 3, blouse with small pleats. 

Fig. 4, a skirt and a blouse piping trims. 

Fig. 5, the blouse and skirt with woven trim in a large pea. 

Fig. b, blouse with gathered neckline. To the pattern of this blouse make at the top of barocci, you need the middle of the neck back and front split in half and connect the points of division with points T1. The pattern on these lines cut to the points T1 and push the backrest by 6 cm in front of CA 9 cm, see Fig. 9.