The drawing of the skirt with two folds (Fig. 78) use the basic patterns. Circle pattern front panels (except the Darts) and apply on the contour of the hips. Line of the bottom left extend of 3-5 cm (Fig. 79).

From the line of mid front cloth at the waist put the segment equal to 1/4 of the poluobhvat waist.

From the received point to the bottom parallel to the middle draw a line cut. Then number the pattern pieces and mark the direction of grain lines. Skirt with two pleats in front, you can sew from any fabric. When the width of the fabric 75-80 cm you will need three lengths of skirt and 10-15 cm, with a width of 90-100 cm or two of length plus 20 cm If the fabric width is 140 cm, it would only take one length plus 10-15 cm

Before you start cutting, you must ensure that you have enough material on the depth of wrinkles. Each pleat requires at 10-16 cm of fabric. In order to calculate how much fabric will be left on the folds, you need to find half of the difference between twice the width of the fabric (if it is 100 cm) and total hip with full boost on the loose fit and seam 8-12 cm: (2 x (100) – (POB + PB) x 2 + 12) : 2 = (200 – (53 + 2) x 2 + 12) : 2 = 51 cm.

Fold the fabric along. Cut the pattern along the line of the cut and put the first part middle of the bend of the fabric. Continue with the hips and put her on 12-16 cm to a depth of folds.

Put the second part so that the beginning lines of her hips coincided with the point of 12-16 cm and Then drag items and combine them to the main contour.

Reduce the depth of the folds along the hem of 1.5–2 cm on each side. With a ruler connect the points 1.5–2 cm with the hips, continue with the direct to the top of the slice. The first part — the upper bend creases. The remaining part of the clean tuck under the fold.

Place the main pattern of the cloth back to the mid-to-fold fabrics. Make allowances for seams and hemming the bottom.

Route copy the seam along the contour lines of the pattern and the top crease of the fold. Cushioning check the stitches of the middle of the front and rear panels. Baste pleats on the front panel and Darts on the back.

Then baste the side sections, please note that on the left side will be the clasp, so the seam should not reach the upper edge on 16-20 see Baste belt or grosgrain ribbons.

Then make a fitting and appropriate patches disperse the seams. Sew the pleats from the waist for 15-35 cm (bridging stitch). Zautyuzhte folds folds on the underside towards the middle. On the front side lay in the folds of the finishing line.

Sew the Darts and the side sections, treat the clasp. Then hem the bottom, sewn all the slices and outwrite skirt.

This model can be supplemented with a belt with a beautiful buckle and rhinestones.