To complete this model (Fig. 124) you'll need need a denim fabric or leather.

Bring basic drawing straight skirts on a blank sheet of paper. The pattern the front piece of cloth can cut from. The pattern of the cloth back, build in the following way.

In the midline front and back panels from the waist down, put a cut line of the yoke (19 cm). From the obtained point to draw a straight line parallel to the side hem. Then the upper and lower lines mark the line of the slits of the folds. To do this, the width of the front and rear panels divide into equal parts, with the middle line of the cloth back, add 3 cm to the length of the clasp. The pattern of the belt make a half the length (38 cm) width 6 cm (2 pieces).

The pattern the straps make on half length — 50 cm, width 10 cm (2 pieces). The details of the pattern number and cut along the planned lines.

Prepared pattern lay out on cloth, folded face inward so that the direction of grain lines on patterns coincided with the direction of the grain lines on the fabric. Patterns pin-pin, obselete on the edges, clearly marking the corners. Then mark all the patterns cue and determine the amount of the allowances for seams and ACC. Then spend the second chalk line on them and carefully cut the fabric. Remove the pattern and cut details how the pins so that they are not shifted forward.

The processing sequence

1. In the midline of the yoke and pleat front cloth lay the thread slip-stitch.

2. Route copy the stitches for all the contour lines of the pattern.

3. Baste and then sew tucks on the yoke and zautyuzhte them toward the middle of the lines.

4. Baste and then sew the side seams at the yoke. Seams Ratatouille.

5. Treat the zipper on the yoke in the middle seam of the back cloth.

6. How, then baste the pleats along the planned lines and proutyuzhte them from the wrong side through damp cheesecloth.

7. On the back panel in the middle seam of the handle and button placket.

8. The lower section of yoke bend on the wrong side of the planned lines and Sametime, then press through damp cheesecloth. Keen on a Flirty skirt, combining copying stitches. Topstitch it at 0.5 cm from the fold. Zautyuzhte seam towards yoke.

9. The straps fold on the middle lines, right sides inward and sew the seam with a margin of 1 cm and Then remove them on the front side, the seam grinding mimetite on the edges and proutyuzhte. At a distance of 0.5 cm around the edges of the straps will lay the finishing line.

10. To the upper cut of the skirt baste the waistband and sew it. Baste to the front side of the upper edge of the belt straps, and fitting precise location on the belt. The second part of podmotsa face put on the front sewn-on waistband and sew on the top section and the ends. Seam primaqiune mimetite and priutyuzhte. Lower cut podmotsa bend on the wrong side so that it covered the seam protecive zone by 0.1–0.2 cm Make finishing line at a distance of 0.5 cm around the edges of the belt.

11. The lower section of the skirt is sewn and hidden hem stitches blind stitch.

12. At the final stage of processing in the belt sewn two loops. Remove the basting and Tutuila skirt sundress. Then sew buttons on the belt and the clasp on the rear panel. For convenience in use the straps and pogoes better to do with gaskets. Padding in the straps cut out 5 cm wide (half the width of the straps) across the length and nastraivatsa on the reverse side at the half, which would then be internal.

As a complement to this model, you can use the belt with glamorous buckle.

Skirt sundress can be supplemented with a bold belt with rhinestones.