Based on the obtained knowledge you can make an outdoor summer sundress with an asymmetrical top line and chesterules skirt. Strap bodice, straps and hem of the skirt is decorated with fabric of a different color (Fig. 127).

Build drawing fundamentals of pattern. Make allowance for the bodice 2 cm in the unfolded state. Side seam position in the middle of the armhole, above the chest line, 1-2 cm (point G4). Prepare a drawing of the Foundation according to your standards. In this case (Fig. 128) measurements standard.

Back. In the drawing, the basis for the design of the top line sundress from point A down the line at measure 10-11 cm Place the point C. Measure 7.5 cm at the line А4П right depth of the shoulder tuck. Mark point C1. Make a line cutout backless through the points C1, C, G4. Swipe parallel to the resulting line line strap width 2-2. 5 cm

Measure the line А4П to the right of the point S1 wide-cut straps 4-5 cm (point P1). From the point P2 to the right of the horizontal measure of 0.7–1 cm — point A4. Make a line of openings through the points P1, A4, G4.

Before. To build the top line of a dress, measure from the point down At 6-7 cm Mark point C2. Then from the point A6 at the line of inclination of the shoulder, measure 6 cm and place the point C3. Make a line neckline forehand through the points S3, S2, G4. When making the neckline of the front, close the Darts. Swipe parallel to the line of the cut on distance of 2-2,5 cm line-width of the strap.

Measure line А10П7 from point C3 wide-cut straps (4-5), see Tuck, the design of this line is also close. Put a point P5. Then horizontally from the point P3 to the left, measure from 0.7 to 1 cm and place the point P8. Draw a line of openings through the points P5, P8, G4.

Finalize the side side tuck and tuck backless scoop line for a snug fit of a dress at the waist. Swipe the dotted line transfer of the Darts from their tops to the lines of the cut strips.

Skirt. For coating lines skirts continue the middle line of the inframammary tuck and tuck back to bottom line. Expand the wedges of the rear cloth skirts. To do this, measure from point N to the left and right 2-6 cm and put the point H1 and H2. Connect the resulting points with the top tuck the backs straight lines. For the following extension of the wedge from a point N3 on the cutting line, measure left and right 2-4 cm and get the points N4 and N5. Connect the resulting points with the top tuck of the front straight lines.

Expand the skirt hem from the side seam of the back. To do this, measure from the point N7 to the right of 2-6 cm and place the point H8, and from the point h6 to the left of 2-6 cm and put a dot N9. Connect the resulting points with points B3 and B4 by straight lines.

This model can be supplemented by the flower of light fabric attached to the shoulder strap.